Filling in badge holes on lacquered drums

Everything for $125? Cymbals? Rogers snare? Now I know I hate you ;)

The only things I have bought that did not come with it was the double pedal, the PDP throne, and a PDP stand. All together I am in it for about $300.
 
Gentlemen please. The holes are 3mm. Nuts and bolts? They are less than 1/8 the inch. I would just leave them alone
 
A round toothpick is about three mm.
I would sand the toothpick down by hand until you can just press fit it in the hole with your finger, cut it flat and dip the tip in stain and use nail polish on the end, then press it into the hole. You don't have to glue it and you can just push them out if you want them removed.
 
I guess I'm missing the issue. If you don't want the holes, replace the badges.
 
To the OP. Post some potos so that we can see what you're talking about.
 
I think it's time to call a local furniture restorer....they'd be able to do it.....hopefully

This. When I worked in a music store years ago there was a piano repairman who could work magic with lacquer stick's. I saw him paint the grain back in to damaged areas and you could not tell where he'd done the work. It's an art. If the result matters, get an artist.
 
Back
Top