Other Gear Discuss Hardware and all other equipment not covered in the other topics

Thread Tools
Old 04-17-2014, 02:44 PM
Cheese Cheese is offline
Join Date: Oct 2012
Posts: 43
Default TD12 Backing Part Mixer


On the TD12 I finally figured out where to go to change the backing track volume (you have to change each part but its the only way as the kit sound wont go louder without the backing doing so too.

However, in the settings screen next to each fader for the instruments in the backing track, there's a lock icon and I cannot figure out how to actually move the faders so I looked at the manual and checked to see if there was any special button combo that was required but it just says:

1. Press [PATTERN] - [F2 (PART)].
2. Press [F3 (MIXER)
3. Press [F1]–[F3] to select the parameter (in my case its F1 - volume)
4. Press [CURSOR (left/right)] to select the part you wish to set
5. Use [+/-], [VALUE], or [CURSOR (up/down)] to make settings.

Here is what the manual says should show up:

Here is what I'm getting:

Iv'e tried using the cursor keys, the _ and + button and the selection wheel, and moving the faders on the brain but it doesn't do anything
Iv'e tried hitting rev end but I think that's for reverb.

Any Ideas?

Last edited by Cheese; 04-17-2014 at 03:35 PM.
Reply With Quote
Old 04-17-2014, 07:31 PM
Brian's Avatar
Brian Brian is offline
Silver Member
Join Date: Apr 2010
Location: New England
Posts: 966
Default Re: TD12 Backing Part Mixer

Good Q
This may get more traction in the drums/hardware part of the forum.
I have a TD-12 and could not figure out how to unlock those, either...simply gave up. :)
Reply With Quote

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are Off
[IMG] code is On
HTML code is Off

All times are GMT +2. The time now is 04:16 AM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Bernhard Castiglioni's DRUMMERWORLD.com