View Single Post
  #5  
Old 06-16-2009, 03:44 PM
Mediocrefunkybeat
Guest
 
Posts: n/a
Default Re: Audio editing question

Is there a way of creating a mono bus and then adding the signal (at 100%) to that and then panning it to the right? You'll end up with a balanced mono output this way. I've actually faked stereo before doing this by having slightly different reverb levels on each bus. My way of doing it is to set up the single source, send to Aux 1 and 2, then to have no level from the original track. Then I will pan Aux 1 fully left and Aux 2 fully right. Does that make sense?
Reply With Quote