View Single Post
  #26  
Old 11-01-2005, 02:32 AM
fourstringdrums
Guest
 
Posts: n/a
Default Re: Hole in new Bass Head

The hole is generally 4-6" and is put at the edge of the head at about the 4:00 position. You can either buy a hole cutting templated or you could just make your own. Cut a circle out of cardboard about a 1/2" bigger than the hole you want, then cut a hole out of cardboard that is the size you want. Place the second hole in the center of the first larger hole and trace around it. Then cut out the hole you just traced. Tape the new "ring" template to the inside of the batter head (tape enough so it stays put while cutting but not so much that you can't get it off), then cut out with an exacto knife. Viola.
Reply With Quote