View Single Post
  #33  
Old 02-16-2007, 07:27 PM
Deathmetalconga's Avatar
Deathmetalconga Deathmetalconga is offline
Platinum Member
 
Join Date: Apr 2006
Location: Boise, Idaho
Posts: 7,221
Default Re: HARDWARE DIY/MODS/REPAIRS THREAD

Quote:
Originally Posted by fourstringdrums View Post
Ok I shortened my hi-hat rod.

The hardware store didn't have any vice clamps left, so I used just a spring loaded clamp to hold the rod to the table.. Only $3. I then cut 8" off the rod. That of course took forever, and the blade kept hanging up so it made it take even longer, but it did it :)

I then used a power drill mounted grinder point to smooth the end, and round it off on the top slightly. That was only about $3 too.

As you can see from the side, it looks like a straight cut and not rounded at all, but from the top you can see the rounding a bit.

It looks pretty good actually, I really surprised myself. The top isn't flawless finish wise, a few scratches, but who cares :) I did make sure to set my hi-hat at the highest height, with the cymbals open the widest I would ever possibly use, just in case. I wound up having more left over than I originally measured, but it's enough to get out of the way of other cymbals and looks clean.

The final result:

I wound up spending $30 at the hardware store though because I had to get a new hacksaw blade and they only sell them in packs ($11) and then I had to buy a heavy dutry ice scraper $10, but that's unrelated to this :)

Thanks for all the help guys!
Good job! Sounds like you thought it through in advance. I encourage you to try other mods and feel free to ask us all if you need advice.

Also, stop showing photos of your Bosphorus. I start drooling all over the keyboard and it gets messy!
Reply With Quote