View Single Post
  #22  
Old 04-30-2014, 02:44 AM
GRUNTERSDAD's Avatar
GRUNTERSDAD GRUNTERSDAD is offline
Administrator
 
Join Date: Apr 2006
Location: Florida's Left Coast
Posts: 16,377
Default Re: Cordless Drill/Driver

Jim just a little advice. when loosening screws to change heads, use a key, in the star pattern to get them very loose. then run them out with the driver. Also don't depend on the numbered torque setting when putting them back on. run them down so they are almost touching the rim then tighten by hand until finger tight, Then use the key to tune.
__________________
219 days until retirement.
Feel. Control the Bounce.
Reply With Quote