View Single Post
  #9  
Old 02-03-2014, 10:32 AM
Les Ismore's Avatar
Les Ismore Les Ismore is offline
Platinum Member
 
Join Date: Jul 2006
Location: Location, Location!
Posts: 3,713
Default Re: Axis Pedal.... revealed

Quote:
Originally Posted by theindian View Post
This thread has been very helpful. I just pulled my pedals out of storage after a long break. I tightened the retainer washers & reset the UDS.

There is still some slop on the heel block, which allows the footboard to slightly move back & forth horizontally. It seems the loc-tite has worn off on the screws with the rolling ball tip.
I assume the way to fix this would be: take the screws out, coat with loc-tite, & then re-install.

Any suggestions?



No, don't coat anything with LOC TITE.

You would heat the heel block in the oven the same way you'd heat and tighten an AXIS UDS.
Reply With Quote