View Single Post
  #8  
Old 01-26-2014, 07:46 AM
theindian's Avatar
theindian theindian is offline
Senior Member
 
Join Date: Feb 2009
Posts: 428
Default Re: Axis Pedal.... revealed

This thread has been very helpful. I just pulled my pedals out of storage after a long break. I tightened the retainer washers & reset the UDS.

There is still some slop on the heel block, which allows the footboard to slightly move back & forth horizontally. It seems the loc-tite has worn off on the screws with the rolling ball tip.
I assume the way to fix this would be: take the screws out, coat with loc-tite, & then re-install.

I had to do this several years ago on another pedal but I have to be careful how tight I set the screws. Too tight & the pedal won't move, or if too loose then there will still be slop. I want to get close to factory.

Any suggestions?
Reply With Quote