Originally Posted by AZStickman
Interesting...... I would be nervous using a heat gun for fear of melting the head, but a hair dryer wouldn't get hot enough to worry about. I may have to give it a try next time I do a head change out....... Terry
I have the same reservations about this. I would also worry about using a heat gun around wood. If too hot, would the plys start to separate, or could the head possibly melt to the bearing edge and infuse itself into the pores of the wood?
I once read that you can remove dents from heads using a hair dryer. It does not work. A heat gun might, however, if one is really careful while doing so.