View Single Post
Old 03-27-2013, 11:28 AM
keep it simple's Avatar
keep it simple keep it simple is offline
Platinum Member
Join Date: Jul 2009
Location: Herefordshire, UK.
Posts: 18,596
Default Re: Restoration of my Sonor Force 2001

Originally Posted by Kalma View Post
Ok I'll try that this evening..

One more question.. I need to measure the inside from the shell. Shall I take the largest or smallest size I get for the diameter of my wood plate?
In theory, you should take the average of the two, but of course, that depends on how much of each extreme measure is present. I'd start at a measure somewhere just under the largest measure then shave down until it fits with some force applied. From that point, reduce as appropriate, byt again, be very careful not to stress the veneer/lacquer!
Reply With Quote