Hey everyone
About a month ago I purchased a Sonor Force 2000, so far it is serving me well, it is a great little kit.
I am slowly(ish) building up all the stands and cymbals etc that I need/want. This is where I encounter my problem. I want to mount a cymbal using a boom arm from the bass drum so it will sit where the 2nd rack tom would normally sit. The problem is that after purchasing a pearl ch 1000 boom arm I realize that it in fact slightly too small to fit in the bass drum mount.
I have measured the bass drum mount and it appears to be about 22mm, which is just slightly off the standard 7/8 inch stand.
So finally I come to my question, is there a way to increase the diameter of the pearl stand to make it fit with out any rattling etc? I was thinking perhaps wrapping it with duct tape where the stand would enter the top of the bass drum. Any thoughts?
About a month ago I purchased a Sonor Force 2000, so far it is serving me well, it is a great little kit.
I am slowly(ish) building up all the stands and cymbals etc that I need/want. This is where I encounter my problem. I want to mount a cymbal using a boom arm from the bass drum so it will sit where the 2nd rack tom would normally sit. The problem is that after purchasing a pearl ch 1000 boom arm I realize that it in fact slightly too small to fit in the bass drum mount.
I have measured the bass drum mount and it appears to be about 22mm, which is just slightly off the standard 7/8 inch stand.
So finally I come to my question, is there a way to increase the diameter of the pearl stand to make it fit with out any rattling etc? I was thinking perhaps wrapping it with duct tape where the stand would enter the top of the bass drum. Any thoughts?