I know this has probably been answered before but I couldn't find an answer.
The way my kit is set up, I have a China on an arm that comes off of a crash on my rack. This positions the China right over my hats. But, the vertical bar on the hats is very high and gets in the way.
How can I trim it down and finish off the trimmed end where it doesn't look al gnarly?
The way my kit is set up, I have a China on an arm that comes off of a crash on my rack. This positions the China right over my hats. But, the vertical bar on the hats is very high and gets in the way.
How can I trim it down and finish off the trimmed end where it doesn't look al gnarly?